Indasa Rhynalox Plus Sandpaper Sheet - 320 Grit for Dry Sanding
230 x 280mm

Indasa Rhynowet Plus Sandpaper Sheet - 400 Grit for Water Sanding
230 x 280mm

Indasa Rhynalox Plus Sandpaper Sheet - 240 Grit for Dry Sanding
230 x 280mm

Indasa Rhynowet Plus Sandpaper Sheet - 600 Grit for Water Sanding
230 x 280mm

600mm masking film roll

INDASA 100mm masking tape

Rhyno Double Sided Sponge - Medium grit

Indasa Rhynalox Plus Sandpaper Sheet - 40 Grit for Dry Sanding
230 x 280mm

Indasa Rhynalox Plus Sandpaper Sheet - 180 Grit for Dry Sanding
230 x 280mm

Hexcel 1184 6oz Fiberglass - 80cm Width

Polishing paste - INDASA HIGH GLOSS 1Kg

Polishing paste - INDASA HIGH GLOSS 250gr

The FCS II Essential plug is designed to offer strength, lightness and reliability

Made from materials resistant to corrosion and mechanical stress, it guarantees excellent support of the fins, even in the most challenging conditions.
Compatible with FCS II fins, it allows for quick assembly without main fixing screws, for simple and efficient launching.

The right/left side is determined by looking at the board from the hull side, viewed from the rear.

This range of trapezoidal gas and vapor filters combines excellent protection, comfort, and balance. Lightweight, low breathing resistance, and well-balanced when mounted on the mask. Provides an excellent field of vision due to its unique trapezoidal shape. The filters can be used on all 3M half and full face masks equipped with a bayonet fitting system, such as the 3M 7500 and 3M 6800. The bayonet system allows the filters to be attached with a click, simplifying installation.

Features

• Filters that protect against: Organic vapors (boiling point > 65 °C), inorganic vapors, acid gases, ammonia and its derivatives
• Standard: EN 141
• Can be combined with a dust filter

Polishing paste - INDASA COMPOUND 1Kg

The FCS II Essential plug is designed to offer strength, lightness and reliability

Made from materials resistant to corrosion and mechanical stress, it guarantees excellent support of the fins, even in the most challenging conditions.
Compatible with FCS II fins, it allows for quick assembly without main fixing screws, for simple and efficient launching.

The right/left side is determined by looking at the board from the hull side, viewed from the rear.